I have a Miyano BNE-51SY with a Fanuc 18i-T control. And I'm getting a reoccurring alarm 436 soft thermal (OVC). I've checked the amps and all have 0's or -'s so the alarm must be on the servo motor itself. I think it's the turret index motor (A axis) but it typically occurs during a boring cycle. Help with Alarm 436 Soft Thermal (OVC). Mohabbatein mp3 download. FANUC Robotics SYSTEM R-J3 i-size, B-size, and Paint Controller Electrical Connection and Maintenance Manual MARM3CONM10801E REV. A Back to Main| Table of Contents| Previous Section| Next Section| Search 3.5 TROUBLESHOOTING USING THE ERROR CODE (1) SRVO-001 SVAL1 Operator panel E-stop o (Explanation) The emergency stop button on the operation box or operator's panel or is pressed. What Is Ovc Alarm In Fanuc RobotsO (Action 1) Release the emergency stop button pressed on the operator's box. O (Action 2) Check the wires connecting the emergency stop switch connector CRT8 for continuity. If an open wire is found replace the entire harness. O (Action 3) With the emergency stop in the released position, check for continuity across the terminals of the switch. If continuity is not found, replace the switch. If continuity is found replace the operator panel PCB. O (Action 4) Replace the Main Board. (2) SRVO-002 SVAL1 Teach pendant E-stop o (Explanation) The emergency stop button on the operator's Teach Pendant was pressed. O (Action 1) Release the emergency stop button on the teach pendant. O (Action 2) Replace Teach Pendant. (3) SRVO-003 SVAL1 Deadman switch released o (Explanation) The teach pendant is enabled, but the deadman's switch is not pressed. O (Action 1) Press the deadman switch to run the robot. O (Action 4) Replace the teach pendant. (4) SRVO-004 SVAL1 Fence open o (Explanation) On the terminal block TBOP1of the panel board, no connection is made between 3 (FENCE1) and 4 (FENCE2). X plane 9 free download. If a safety fence is connected between 3 (FENCE1) and 4 (FENCE2), the door of the safety fence is open. Ovc AlarmFanuc Soft Thermal Ovc AlarmO (Action 1) If a safety fence is connected, close the door. O (Action 2) Check the switch and cable connected to 3 (FENCE1) and 4 (FENCE2). O (Action 3) When this signal is not used, make a connection between 3 (FENCE1) and 4 (FENCE2). O (Action 4) Replace the panel PC board.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |